First Installation; Automatic Channel Search; Satellite Mode - Tele System PALCO SC10 Manual

ENGLISH

First Installation

At the first installation, select the OSD language and the country, enter the PIN (4 digits) and
confirm it to proceed. Select the signa type (DVB-T2 or Satellite) to launch the channel
scanning and press OK.

Automatic channel search

Press MENU à Channel à Auto Tuning and confirm with OK button. Select the country
(default ITALY) and press OK to launch the scanning.
At any time, pressing EXIT or Menu, the scanning can be stopped.
WARNING! Automatic channel searching deletes all channel lists previously saved.
DVB-C mode (via cable) is available to receive the digital channels, select DVB-C and press
OK to launch the scanning.
WARNING! Make sure to not select this mode in case of traditional terrestrial antenna
system.
WARNING! The reception and therefore the viewing of digital terrestrial channels depends
on the level and the quality of the antenna signal available The signal varies according to the
area in which you live, to the correct orientation/functioning of the antenna system and to
the quality of the signal transmitted by the digital terrestrial repeaters
Channel list editing.
Press MENU à Channel à Edit Program and confirm pressing OK. Once displayed the list,
the options are:
RED (Delete): select one or more channels, delete them pressing RED button.
Blue (Skip): select the channel and press BLUE button, once activated the channel can be
selected with the numeric keys of remote control unit.
Yellow (Move): to move a channel, select the channel you want to move, press the Yellow
button, use arrow keys to move the channel to the desired position or enter the desired
position number, then press OK to confirm.

Satellite mode

If you choose satellite, you can choose to load a default satellite channels list by pressing OK
and confirming Yes (left arrow) to the confirmation request; or proceed with normal
installations, once the satellite parameters are set, scan type, channel type and type of
service, by pressing OK and choosing No (right arrow) on the next screen.
To activate the digital channel reception mode, press the Source à Satellite. You can scan
the frequencies available with your satellite antenna system, automatically searching for all
the satellite channels from the first installation or through an automatic scanning available
in the Channels menu.
Impostazione Antenna
the basic settings to allow the use of the TV with a single Universal LNB (Low Noise Block
converter) system (commonly used for satellite systems in Italy); in the event your system is
done with a different configuration, you must appropriately change the antenna settings.