LYSON C-01 Manual page 14

that the heater is off.
2. The knob on the heater panel shall be in the minimum
position on the scale (switched off).
3.
After connecting the device to the mains, turn the knob on
the heater panel to the half of the range and observe the
temperature on the thermometer (5)
4. If needed, correct the knob position depending on the
temperature required.
7. Storing the honey creaming machine with a
heating mantle
Once the activities related to the device operation have
terminated, the device must cleaned and dried thoroughly.
Prior to the device start-up, in case when it has been
transferred from the room with lower temperature to the room
with higher temperature, one must wait until it has reached the
ambient temperature. To be stored in dry rooms with
temperatures over 0º C
Prior to every season, an additional inspection must be
performed for technical issues and in case any fault has
been detected, a service point must be contacted.
8. Cleaning and maintenance
Prior to the maintenance, the plug must be taken out from
the mains.
Prior to the first use, the creaming machine must be washed
and dried thoroughly.
In order to wash thoroughly, it is recommended to dismantle
the beam with the controller, engine, gear and stirrer. The bolts
fixing the beam to the tank must be unscrewed and the
mechanism removed.
The device shall be washed with hot water with added agents
permissible to be used in food industry. The device shall be
washed with soft flannel fabrics, remember to protect any
electrical elements. Once cleaned, rinse with pure water and
dry.
Creaming machine shall be stored in a dry room.
None of the device elements shall be maintained with
chemicals.
9. RECYCLING
Worn-out product must be removed as waste only within
selective waste collection organised by the Network of
Communal Electric and Electronic Waste Collecting Points. A
customer is entitled to return the used equipment to the
electrical equipment distributor network, at least free of charge
and directly, if the device to be returned is of proper type and
serves the same purpose as the newly purchased device
10. Guarantee
Product purchased from "Łysoń' company are encompassed
by the manufacturer's guarantee.
The guarantee duration equals 24 months.
IMPORTANT!
A receipt or an invoice is issued for each product purchased.
Detailed guarantee terms and conditions, see
www.lyson.com.pl