Before You Begin - Razor UB1 Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because your
scooter was assembled and packed at the factory, there should not be any problems, even if the box has a few scars
or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 5 hours for charge (see page 7 for charging information).
Charger
Note: Charger design may
vary from one shown
Throttle
Brake Lever
Front Fork
Required Tool
5 mm
Allen Wrench
2.
Folding
Handlebar
Folding Mechanism
Hook-and-Loop
Strap
1.
Lock Point
Foot Pegs
Pneumatic Tire
Seat
Quick-Release Lever
Charger Port
Hub Motor
Kickstand
3
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR SCOOTER.
Razor scooters have been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
not be compatible and will void
the warranty.
Product ID Locations:
(See locations to the left)
1. Underneath Product
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• UB1
• Charger
• Owner's Manual
• 5 mm Allen Wrench