User Instructions; Introduction; Air Controls; Door Handle - Nectre Fireplaces INBUILT Operating Instructions Manual

Table of Contents

Advertisement

2

USER INSTRUCTIONS

1.

INTRODUCTION

Before use of this appliance please read these instructions
fully.
WARNING: ANY MODIFICATION OF THE APPLIANCE
THAT HAS NOT BEEN APPROVED IN WRITING BY THE
TESTING AUTHORITY IS CONSIDERED AS BREACHING
AS/NZS 4013.
WARNING: DO NOT USE FLAMMABLE LIQUIDS OR
AEROSOLS TO START OR REKINDLE THE FIRE.
WARNING: DO NOT USE FLAMMABLE LIQUIDS OR
AEROSOLS IN THE VICINITY OF THIS APPLIANCE
WHEN IT IS OPERATING.
WARNING: DO NOT STORE FUEL WITHIN HEATER
INSTALLATION CLEARANCES.
WARNING: WHEN OPERATING THIS APPLIANCE AS AN
OPEN FIRE USE A FIRE SCREEN.
WARNING: OPEN AIR CONTROL (AND DAMPER WHEN
FITTED) BEFORE OPENING FIRING DOOR.
CAUTION: THIS APPLIANCE SHOULD NOT BE
OPERATED WITH A CRACKED GLASS.
CAUTION: THIS APPLIANCE SHOULD BE MAINTAINED
AND OPERATED AT ALL TIMES IN ACCORDANCE WITH
THESE INSTRUCTIONS.
CAUTION: THE USE OF SOME TYPES OF
PRESERVATIVE- TREATED WOOD AS A FUEL CAN BE
HAZARDOUS.
The appliance or flue system should not be modified in any
way without the written approval of the manufacturer.
Extractor fans or cooker hoods must not be placed in the
same room or space as this can cause appliance to emit
smoke into the room.
1.1.

AIR CONTROLS

The Nectre Inbuilt (MK2) has two air controls for
controlling the fire.
Top air slide: This allows air to enter the firebox from above
the door where it is then drawn down into the base of the
fire while keeping the glass clean.
Bottom air slide: This allows air to enter directly into the
base of the fire and is used as a boost especially when
getting the fire up to temperature.
1.2.

DOOR HANDLE

Warning: door handle may get hot if appliance has been left
in High burn setting for an extended period of time, in which
case use a protective glove or equivalent to open.
Open the top air slide before opening the door to eliminate
the chance of backdraft and/or smoke entering the room.
1.3.

FAN

The fan can be used to spread heat around the room
quicker, as well as distribute heat into other rooms. It does
not have to be on if not required. Plug the lead from the
unit into a power-point. This model has a remote control
supplied with the heater used to turn the fan on and
determine the chosen speed. See over page:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Inbuilt mk2

Table of Contents