Advertisement

Quick Links

Nectre N60

Operating Instructions

Efficient—Warm—Friendly
Keep instructions in a safe place for future reference
Do not throw away
Pecan Engineering Pty Ltd proudly supports the activities of Landcare Australia through its membership of the AHHA

Advertisement

Table of Contents
loading

Summary of Contents for Nectre Fireplaces N60

  • Page 1: Operating Instructions

    Nectre N60 Operating Instructions Efficient—Warm—Friendly Keep instructions in a safe place for future reference Do not throw away Pecan Engineering Pty Ltd proudly supports the activities of Landcare Australia through its membership of the AHHA...
  • Page 2: Air Controls

    USER INSTRUCTIONS 1. INTRODUCTION AIR CONTROLS Before use of this appliance please read these instructions The Nectre N60 has a single top air control for controlling fully. the fire. WARNING: ANY MODIFICATION OF THE APPLIANCE THAT This air control allows air to enter the firebox from above...
  • Page 3: Using Appliance For First Time

    2. USING APPLIANCE FOR FIRST TIME 5. RUNNING THE APPLIANCE First few times the appliance is lit, it will give off some High heat output: odorous fumes. This is caused by the paint curing.  After establishing the fire and loading it with larger Do not touch the paint work while it is curing otherwise it pieces of wood, leave it running with the air control can leave a permanent mark on the appliance.
  • Page 4 6. BURNING TIPS 7. ASH REMOVAL Fuel Quality Depending on the type of wood burnt and frequency, the ashes will need removing every 2 to 6 weeks. 1. Use wood with a moisture content of less than 20%. Excess ashes should be removed when necessary, placed in Logs should not feel moist or damp, or have moss and a non-combustible container such as the ash pan beneath fungal growths.
  • Page 5: Troubleshooting Tips

    look for black creosote build-up. If only a fine black 11. TROUBLESHOOTING TIPS powdery layer then that is normal, but if built up layers of creosote can be seen, then the flue needs 1. Glass in door blackening cleaning. This can have several possible causes: 3.
  • Page 6: Maintenance And Servicing

    1. REPLACEMENT OF FIREBRICKS The purpose of the firebricks in the heater is to increase The Nectre N60 is fitted with two 6mm thick steel baffle thermal mass and to guarantee the longevity of the steel plates which help to retain the heat in the firebox by firebox.
  • Page 7: Fitting A New Door Glass

    When get to the end there will be a small amount of 4. FITTING A NEW DOOR GLASS excess rope. Trim this to the right length, remove the backing from the adhesive silver tape supplied with This task may be easier with the door removed from the the rope and wrap the tape around the end that has appliance and laid horizontally on a work-bench.
  • Page 8: Warranty

    WARRANTY Pecan Engineering Pty. Ltd. warrants this stove to be able to operate under normal use and service and within 10 years from the date of the original purchase on the terms herein shall repair or replace without cost to the original customer any part thereof which shall be returned to our factory, transportation charges prepaid and which our inspection shows would prevent operation.

Table of Contents