Table of Contents
Advertisement
8
4.
FITTING A NEW DOOR SEAL
This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
1.
Remove any old seal from the door.
2.
Clean out the groove in the door that held the seal
using a flat-end screw driver or equivalent.
3.
Run a thin bead of clear roof and gutter silicone
along the groove.
4.
Starting at one end, press the new door seal rope
into the groove on the door.
5.
Refit the door if it has been removed and close.
APPLY SILICONE
5.
ADJUSTING DOOR LATCH
If the door does not close firmly, the latch can be adjusted.
The latch is fastened onto the door with two removeable
washers. Use a socket wrench to undo the M12 nut, then
remove one of the washers directly beneath the nut.
Securely fasten latch assembly again.
Close the door with the door handle to test for any
improvement. If no improvement, remove second washer.
6.
CHANGE FAN CONTROLLER
FREQUENCY
The frequency used by the fan remote control can be
changed if interferences are experienced in the home.
Unplug the power lead before proceeding.
6.1.
REMOTE CONTROL RECEIVER
The remote control receiver has four small switches on the
side, as seen in the photo below. Change the switch setting
to something different than current setting. Remember
this switch setting as it will need to be replicated on the fan
controller.
To access the remote control receiver:
1.
Remove the fan bar from the front of the heater by
lifting up, then pulling away from the heater.
2.
The reciever unit is fastened in place within the
removed fan bar.
3.
Remove the reciever if necessary by removing the
two M6 philips head screws from the underside.
4.
Repeat steps 1 to 3 in reverse to re-install.
Advertisement
Table of Contents
