Table of Contents
Advertisement
To remove the baffle:
1.
Firebricks need to be removed before the baffle
plate can be removed (refer to "1. Replacment of
Fire Bricks" on page 6 for how to remove them).
2.
Slide the baffle plate forward until it is clear of the
rear support rods.
3.
Lower the rear of the baffle plate until the front edge
of the baffle plate has cleared the front support
rods.
4.
Turn the baffle plate on an angle so that it can be
removed through the door opening.
5.
Repeat steps 1-4 in reverse to replace with the new
baffle.
BAFFLE
SUPPORT
RODS
3.
FITTING NEW DOOR GLASS
This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
To replace the door glass:
1.
Two stainless steel strips hold the glass in place.
Remove the four screws from the stainless steel
strips with a 3mm hex key.
2.
Take out the glass, and check if the grey rope
beneath needs replacing. If so, replace this rope
as well.
FIBREGLASS ROPE
3.
Position the new glass on top of the grey rope and
re-fit the stainless steel strips and screws.
4.
Take extra care not to over-tighten the screws,
otherwise the glass will crack when the heater gets
hot and the door expands.
5.
Dispose of the old glass in a responsible manner.
7
Advertisement
Table of Contents
