Page 2
Glen Dimplex Australia proudly supports the activities of Landcare Australia through its membership of the AHHA. NECTRE FORM 1 (NF1-22) VERSION 1.0...
USER INSTRUCTIONS INTRODUCTION 1.1. AIR CONTROLS Before use of this appliance please read these instructions The Nectre Form 1 features a single air control system. fully. This single control modulates the amount of oxygen that enters the firebox at two points - at the top of the door WARNING: ANY MODIFICATION OF THE APPLIANCE glass, as well as directly at the base of the fire controlling THAT HAS NOT BEEN APPROVED IN WRITING BY...
USING APPLIANCE FOR THE FIRST LIGHTING THE FIRE TIME Place firelighters and/or paper and dry kindling wood in the base of the firebox. The first few times the appliance is lit, it will give off some odorous fumes. This is caused by the paint curing. Fully open the air control located on the bottom left of the door by sliding it all the way clockwise.
BURNING TIPS 5.2. LOW HEAT OUTPUT The heat output of the appliance can be reduced by 6.1. FUEL QUALITY closing the air control (sliding all the way counter- Use wood with a moisture content of less than 20%. Logs clockwise) which will restrict the oxygen supplied to the should not feel moist/damp, or have moss/fungal growths.
CLEANING THE FLUE For advice on the correction of persistent flue problems consult your supplier/installer for more detail. Check inside of flue prior to each season for any build-up of creosote (wood tar). To do this: ASH REMOVAL First remove the baffle (refer to “2. Replacement of Depending on the type of wood burnt and frequency, the Baffle”...
TROUBLESHOOTING TIPS 11.1. GLASS IN DOOR BLACKENING This can have several possible causes: ● Burning unseasoned wood — if the wood is too wet, it will cause the glass to blacken. ● Appliance operated at low temperature — after an overnight burn where the air slide control has been fully closed, the glass may have blackened.
MAINTENANCE AND SERVICING REPLACEMENT OF VERMICULITE Vermiculite is a naturally occurring aluminium-magnesium silicate material that is non-toxic and environmentally friendly. The purpose of the vermiculite bricks in the appliance is to promote a higher internal temperature resulting in a longer burn time and greater efficiency. Over time the vermiculite may become cracked and crumble away.
REPLACEMENT OF BAFFLE PLATE Carefully pivot burn tubes downwards from the front edge. The rear tips of the burn tubes pass AND BURN TUBES through the rear of the firebox - pull burn tubes The 6mm thick steel baffle plate helps to retain the heat in forwards slightly to dislodge - this will allow the burn the firebox by lengthening the path of the flame as well as tubes and baffle to be removed from the firebox.
FITTING A NEW DOOR SEAL FITTING NEW DOOR GLASS Remove the door from the heater and lay it horizontally on Due to the curvature of the glass, the door seal and door a work-bench. seal retainers must also be removed from the door in order to gain access to the glass.
ADJUSTING DOOR LATCH Take out the glass, and the flat grey glass seal rope beneath it. The glass replacement kit will come with Over time, the door seal can become compressed, replacement glass seal and door seal ropes. resulting in a less than adequate seal between the door and the front face of the firebox.
REPLACEMENT SPARE PARTS LIST PART NO. PART DETAIL N900-372 Vermiculite set 2 @ 255 x 189 x 25mm with angled edge 2 @ 255 x 132 x 25mm with two angled edges 1 @ 210 x 110 x 25mm N110-072 Brick retainer Stainless steel N110-058...
WARRANTY Glen Dimplex Australia Pty. Ltd. warrants this stove to be able to operate under normal use and service and within 10 years from the date of the original purchase on the terms herein shall repair or replace without cost to the original customer any part thereof which shall be returned to our factory, transportation charges prepaid and which our inspection shows would prevent operation.
Page 16
Glen Dimplex Australia Pty Ltd 8 Lakeview Drive, Scoresby Victoria 3179 Australia T: 1300 556 816 | F: 1800 058 900 General and Sales Enquiries: flame@glendimplex.com.au Technical Service: service@glendimplex.com.au www.glendimplex.com.au...