Battery Usage; Battery Installation; Battery Removal; Battery Charging - UTStarcom CDM-4500 User Manual

BATTERY USAGE

C

BATTERY INSTALLATION

H
1
u
1
Place the battery on the back of the handset
and slide into place.
until it locks into place.

BATTERY REMOVAL

u
1
Pull down the release latch, lift up the
v
battery and
handset.
If the battery is not correctly placed in the compartment, the
handset will not turn on and/or the battery may detach during use.
v
Push the battery down
remove the battery from the
10
BATTERY USAGE

BATTERY CHARGING

POWER CONNECTION

1
Plug the AC Charger into a standard outlet.
2
Plug the other end of the AC Charger into the
bottom of your phone. The battery must be
installed onto the phone.
• When you charge the battery with the phone power off, you
will see a charging status screen. You cannot operate the
phone until it is powered on.
• The battery is not charged at the time of purchase.
• Fully charge the battery before use.
• It is more efficient to charge the battery with the handset
powered off.
• The battery must be connected to the phone in order to charge it.
• Battery operating time gradually decreases over time.
• If the battery fails to perform normally, you may need to replace
the battery.
11
C
H
1