Fisher Xtreme V 44600-1 Installation Instructions Manual page 6

44600-1, 44650-1, 44675-1, 44685-1, 44695-1, 44775-1, 44785-1, 44795-1
5. Stand the blade and T-frame upright and support
in a level position using block under the main
T-frame tube. Install the blade guides.
6. Install the center snow defl ector using two
3/8" x 1-1/4" cap screws, and 3/8" locknuts.
7. Install a 3/8" U-bolt through a link in one end of
the lift chain. Attach U-bolt and chain to the holes
on the driver-side T-frame brace with 3/8" lock
washers and nuts. Tighten.
Lift Chain
U-Bolt
Nuts
Lit. No. 44227, Rev. 10
Lock Washers
8. Place U-bolt on extension spring. Place 3/8" nut
on each side of U-bolt. Place U-bolt through
mounting tab on T-frame. Place lock washers and
3/8" nuts on U-bolt and tighten.
Lock Washers
Extension Spring
U-Bolt
9. Rotate the push assembly and fasten in the middle
position using two 3/4" x 2" cap screws and
3/4" locknuts. Tighten until assembly is secure, but
do not torque at this time.
3/4" x 2"
Cap Screw
6
Extension
Spring
U-Bolt
Nut
Mounting Tab
Lock Washer
Nut
Nuts
Nuts
3/4"
Locknuts
3/4" x 2"
Cap Screw
June 1, 2008