Blade Drop Speed Adjustment; Final Adjustments - Fisher Xtreme V 44600-1 Installation Instructions Manual

44600-1, 44650-1, 44675-1, 44685-1, 44695-1, 44775-1, 44785-1, 44795-1

BLADE DROP SPEED ADJUSTMENT

WARNING
Keep 8' clear of the blade drop zone when it is
being raised, lowered or angled. Do not stand
between the vehicle and blade or directly in front
of blade. If the blade hits you or drops on you,
you could be seriously injured.
The quill in the top of the valve manifold adjusts the
blade drop speed.
1. Lower the blade to the ground before making
adjustment.
2. Turn the quill IN (clockwise) to decrease drop
speed. Turn the quill OUT (counterclockwise) to
increase drop speed.
NOTE: To access the quill on the XtremeV™
hydraulic unit, raise top cover retainer, remove
bottom cover retainer and remove rear cover.
3. Stand 8' clear of the blade drop zone when
checking adjustment.
4. On the XtremeV unit, replace cover and reinstall
the top and bottom cover retainers.
Lit. No. 44227, Rev. 10
Top
Cover
Retainer
Quill
Bottom
Cover
Retainer
12

FINAL ADJUSTMENTS

1. With snowplow attached to the properly ballasted
vehicle and blade lowered to ground, the T-frame
should be parallel with the ground. If not, place the
snowplow in the scoop position.
T-Frame
Push
Assembly
2. Loosen the front fasteners for the push assembly
to T-frame connection, but do not remove them.
Next, remove the rear fasteners from the push
beam to T-frame connection. Level the T-frame.
3. Select the hole in the rear of the T-frame that
is aligned closest to the rear holes in the push
assembly. Reassemble the previously removed
fasteners into the rear holes and tighten all
fasteners.
Select the
hole best
aligned with
rear holes in push assembly
Front
Fasteners
Rear Fasteners
June 1, 2008