Safety Definitions; Warning/Caution And Instruction Labels - Fisher Xtreme V 44600-1 Installation Instructions Manual

44600-1, 44650-1, 44675-1, 44685-1, 44695-1, 44775-1, 44785-1, 44795-1

SAFETY DEFINITIONS

WARNING
Indicates a potentially hazardous situation
that, if not avoided, could result in death or
serious personal injury.
CAUTION
Indicates a potentially hazardous situation
that, if not avoided, may result in minor or
moderate injury. It may also be used to alert
against unsafe practices.
NOTE: Indicates a situation or action that can lead
to damage to your snowplow and vehicle or other
property. Other useful information can also be
described.
Lit. No. 44227, Rev. 10
WARNING/CAUTION AND INSTRUCTION
LABELS
Become familiar with and inform users about
the warning labels on the back of the blade and the
instruction label on the headgear.
NOTE: If labels are missing or cannot be read, see
your sales outlet.
Headgear
Jack
(fully raised)
Headlamp
Bracket
Pin Release
Handle (raised)
Stop
Jack
Jack
Lock
Handle
Pin Release
Handle
(lowered)
Connecting
Jack
Pin
Jack
(lowered)
U.S Patents 4,999,935; 5,353,530; 5,420,480; 6,253,470; 6,944,978; RE 35,700;
CAN Patent 2,060,425; and other patents pending.
Read Owner's Manual For Complete Instructions
1. Place control in Lower/Float to put blade
down.
2. Pull and hold Jack Lock out. Jack will drop to
ground. Then pull Pin Release Handle away
from Stop and Jack Lock. Release Jack
Lock. Verify Jack is locked by trying to lift
Jack.
2
Warning/Caution Label
Instruction Label
1. Push
Pin Release
Handle down to pull
out Connecting Pins.
2. Drive vehicle slowly to engage
Pushplates into Attachment Arms.
3. Stand in front of blade. Fully raise Pin Release
Handle to release Connecting Pins.
4. Push Headgear toward vehicle to allow Connecting Pins
Pushplate
to fully engage Pushplates. If unable to push Headgear
Attachment from in front of blade, stand in front of Headgear on driver
Arm
side and push Headlamp Bracket.
5. Pull out Jack Lock. Push Pin Release Handle into Stop.
6. While holding Jack Lock out, use Jack Handle to raise
Jack fully. Release Jack Lock.
7. Attach all electrical connectors.
3. Stand in front of blade. While pushing Headgear toward
vehicle with left hand, push Pin Release Handle down to
disengage Connecting Pins. Make sure Connecting
Pins are fully retracted. If unable to push Headgear from
in front of blade, stand in front of Headgear on driver side
and push Headlamp Bracket.
4. Detach all electrical connectors.
27451
June 1, 2008