Hydraulic Fittings - Fisher Xtreme V 44600-1 Installation Instructions Manual

44600-1, 44650-1, 44675-1, 44685-1, 44695-1, 44775-1, 44785-1, 44795-1

HYDRAULIC FITTINGS

Do not use thread sealant/tape on hoses and fi ttings.
This could damage the product. Install all fi ttings into
rams and hydraulic unit using the following procedure
and fi tting orientation illustrations:
1. Remove plug from ram or manifold port. Use a
rag to catch residual fl uid when removing manifold
plugs.
2. Turn the jam nut on the fi tting as far back as
possible.
3. Lubricate the O-ring with clean hydraulic fl uid.
4. Screw fi tting into port by hand as far as it will go.
The washer should contact port face and shoulder
of the jam nut threads.
5. Unscrew fi tting to proper position, no more than
one full turn.
6. Use one wrench to hold the fi tting body in position
and tighten the jam nut with another wrench until
the washer again contacts port face. Tighten
1/8–1/4 turn to lock fi tting in place.
Lit. No. 44227, Rev. 10
45°
Elbow
Long 90°
10°
Elbows
10°
10°
Hydraulic
Unit
10°
90°
90°
Elbow
Elbow
PS Angle Ram DS Angle Ram
(Rod End)
8
90° Elbows
0°
10°
30°
Cap
10°
Lift Ram
(Rod End)
June 1, 2008
15°
90°
Elbow