Philips FC8820 Manual page 24

ENGLISH
24
Problem
The robot does
not start cleaning
when I press the
on/off button.
E1 is on the
display.
E2 is on the
display.
E3 is on the
display.
E4 is on the
display.
E5 is on the
display.
E6 is on the
display.
The robot does
not clean properly.
Cause
The rechargeable battery is
empty.
The small plug is still inserted
in the socket on the robot.
One or both wheels are stuck. Set the on/off switch to 'off '. Remove the fluff, hair,
One or both side brushes
are stuck.
The top cover is not present
or is not closed properly.
The bumper is stuck.
The robot was lifted while it
was cleaning.
The robot is cleaning a dark
or black surface, which triggers
the drop-off sensors. This
causes the robot to move in
an unusual pattern.
The robot is cleaning a floor
that reflects sunlight quite
strongly. This triggers the drop-
off sensors and causes the
robot to move in an unusual
pattern.
The rechargeable battery has
not been inserted correctly.
The power switch is set to
'off ' while the robot is on the
docking station.
The bristles of one or both
side brushes are crooked
or bent.
Solution
Charge the rechargeable battery (see chapter
'Preparing for use').
The robot does not work on mains power.
It only works on its rechargeable battery.
Therefore, always disconnect the adapter from
the robot and the mains before use.
thread or wire that is caught around the wheel
suspension.
Clean the side brushes (see chapter 'Cleaning
and maintenance').
When the top cover is not present or is not
closed properly, the robot does not work.
Place the top cover on the robot properly.
Press the on/off button to stop the robot.
Lift the robot so that its bumper comes free.
Press the on/off button to stop the robot.
Then press the on/off button again to make the
robot resume cleaning normally.
Press the on/off button and then move the robot
to a lighter coloured piece of the floor. If the
problem continues to occur on lighter coloured
floors, go to www.philips.com/support or contact
the Consumer Care Centre in your country.
Close the curtains to block sunlight from entering
the room.
See chapter 'Before first use' for instructions on
how to insert the rechargeable battery.
Set the power switch to 'on'.
Soak the brush or brushes in warm water for
a while. If this does not restore the bristles to
their proper shape, replace the side brushes.
See chapter 'Replacement' for instructions on
how to replace the side brushes.