Table of Contents
Advertisement
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
The hook-in racks are all fixed to the side walls of the cooking
compartment at four points.
Removing the hook-in racks
Take hold of the bottom of the hook-in rack and pull it slightly
1.
forward.
The lower hooks of the hook-in rack are released.
Take hold of the top of the hook-in rack and pull it up and out
2.
of the drill holes.
$
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service, as you may be able to
remedy the fault yourself.
Problem
The appliance does not work.
The oven lighting has failed.
The gas burner does not ignite.
The flame (oven) does not burn
through all outlet openings.
All dishes prepared in the oven may
burn within a short period of time.
The door panel steams up when the
oven is hot.
22
%
Possible cause
Defective circuit breaker
Power cut
Oven light is faulty
Power cut or damp ignition plugs
Normal build-up of dirt
Defective thermostat
Normal occurrence; caused by the differ-
ence in temperature.
Cleaning the hook-in racks
Clean the hook-in racks with washing-up liquid and a sponge or
brush.
Inserting the hook-in rack
Insert the upper hooks into the drill holes in the side panel.
1.
Pull the hook-in rack slightly downwards and insert the lower
2.
hooks into the drill holes.
$
ã=
Risk of injury!
Incorrect repairs may cause serious hazards. Repairs to the
appliance may only be performed by a qualified person. If
repairs are required, contact the after-sales service.
Malfunction table
Remedy/information
Look in the fuse box and check that the circuit
breaker is OK.
Check whether the kitchen light is working.
Change the oven light bulb. (see section
"Replacing oven light")
Light the gas burner with a gas lighter or a
match.
The burner must be professionally cleaned.
Call the aftersales service.
Not possible; this has no effect on oven per-
formance.
%
Advertisement
Table of Contents
