Converting The Gas Type; Hotplate Burners; Oven Burner - Siemens HG72G.1 M Series Instructions For Installation And Use Manual

Converting the gas type

If the appliance is not already set up for the existing type of
gas, the appliance must be converted. The conversion to a
different type of gas must be carried out by an authorised
expert in accordance with the applicable regulations. The rating
plate indicates the type of gas and the gas pressure which
have been pre-set in the factory.
The rating plate is located on the inside of the storage
compartment flap.
In order to convert to a different type of gas, the nozzles must
be replaced and the low flame and primary air may have to be
adjusted.

Hotplate burners

Replacing the nozzles
Disconnect the appliance from the power supply.
1.
Remove the pan supports.
2.
Remove the burner caps (A) and burner cups (B) from the
3.
burners (C).
$
%
&
Remove the nozzle (D) and replace it with an appropriate
4.
nozzle for the new type of gas (see section "General nozzle
table").
'
Replace the gas label with the new gas label that was
5.
supplied with the nozzle set.
Place each burner cup (B) on the burner (C).
6.
Position the relevant burner cap (A) exactly on top of the cup
7.
(B).
$
%
&
Refit the pan supports.
8.
Setting the minimum gas flow
Switch on the gas burner.
1.
Turn the control knob for the gas burner towards the small
2.
flame setting.
Remove the control knob for the gas burner.
3.
Adjust the internal setting screw until a stable flame is
4.
burning correctly.
Loosen the setting screw to increase the gas flow or tighten it
to decrease the gas flow.
Check that the flame does not go out when the gas flow is
quickly changed between maximum and minimum, and vice
versa.
The setting is correct when the height of the small flame is
approx. 3 to 4 mm.
HG72G8155M, HG72G7155M, HG72G7125M, HG72G6155M,
HG72G5154M, HG72G4124M:
HG72G3054M, HG72G2054M:
Refit the control knob for the gas burner.
5.

Oven burner

Replacing the nozzles
Remove the removable floor of the oven by undoing the 2
1.
screws at the front and pulling the floor out upwards and
towards the front.
31