Changing Fuse; Error Code - SAESHIN Oz Instruction Manual

CHANGING FUSE

Fuse is placed in the small box beside of the power connector at the back side.
Take out the fuse box and change the fuse.

ERROR CODE

In case of overload, breakage and motor coil burning, motor stops and control box shows the error
code on rpm display box. From this function, the reason of the breakage or faulty and conditions of
each part can be noticed.
Error Cause
code
E1
Setting error
Caused by abnormal motor
inicial operation
E2
Over current error
Occurs in case of ussing the
handpiece for a long time
on overloaded, the wrong
assembling after
disassemble and f troubling
of bearings and motors.
E3
Control box error
E0
Handpiece connect error
Releasing Action
Check the power cord and motor
connector connected well.
Check if the chuck is open. Turn the
power on again.
If runs normally, error will be
disappeared.
Make inquiries to manufacturer in case
of occurring same error
Push the motor Restart running the control box after
button, or foot keeping it stops for about 10 minutes.
controler If the same error occurs constinuously,
ask to manufacturer.
Ask to manufacturer.
Please, disconnect the handpiece and
reconnect again.
In the same thing happens, please
contact our headquaerters company.