SAESHIN Oz Instruction Manual page 14

CHECK POINT IN CASE OF PROBLEM
If the product does not work after checking, please contact to the seller or manufacturer.
Problem
The motor does
not run
CAUTIONS
1. Memory:
Memory saves the conditions of direction and hand foot selection on turning off the power.
Therefore, be careful when the power is on.
2. Do not work at a dangerous place.
Do not use the control box in a humid place.
3. Transport and storage conditions:
Temperature: 10 – 40 ºC
Humidity: 30 – 75 % RH
Atmospheric pressure: 700 hPa – 1060 hPa
4. Our handpiece and pedal need to be used with only our control box.
5. Check for any troubles, including vibration of bur, at low speed, and then start high speed.
6. Operate the speed control dial at control box softly.
7. Turn off the power or set the RPM at zero and then change the bur.
8. Do not turn on the power of control box while the collet chuck of handpiece is open (E1 error).
9. Maximum temperature of applied parts:
The head of handpiece is applied parts.
The maximum temperature of applied parts are below:
39 ºC at ambient 25 ºC or 54 ºC at ambient 40 ºC.
Therefore use this parts carefully
Check
The power lamp is out when
the power switch is on
The handpiece does not run
when the hand/foot switch is
on and power lamp is on
The handpiece does not run,
when the power lamp is on
The RPM does not increase
Cause
The control box may have a
problem
Check the connection of
power cord
Check if the chuck is open
(E1 error)
Check the connection
between the control box and
handpiece cord
Check if the cord is broken
down or disconnected
The control box may have a
problem
Solution
Check the fuse.
Check the power
switch.
Connect the
power cord
properly.
Lock the chuck.
Connect the
handpiece
properly.
Ask to the seller.
Ask to the seller.