Panasonic WH-MDC05H3E5 Service Manual page 11

11.1.6 Installation of Network Adaptor and Base Pan Heater
11.1.6.1 Network Adaptor and Installation (Optional)
1. Open the Cabinet front plate and Cabinet top
plate, then connect the Network Adaptor Cable
to the CN-CNT connector on the printed circuit
board.
Pull the cable out of the Mono bloc unit so that
o
there is no pinching.
If an optional PCB has been install in the
o
Mono bloc unit, connect the CN-CNT
connector to Optional PCB.
Network Adaptor
cable
Without Optional PCB
2. Insert a flat head screwdriver into the slot on
the top of the adaptor and remove the cover.
Connect the other end of the CN-CNT cable
connector to the connector inside the adaptor.
Slot
11.1.6.2 Base Pan Heater (Optional)

It is strongly recommended to install a Base Pan Heater (optional) if the Mono bloc unit is installed in cold climate
area. Refer the Base Pan Heater (optional) installation instruction for details of installation.
Network Adaptor cable
With Optional PCB
Connector
3. On the wall near the Mono bloc unit, attach the
adaptor by screwing screws through the holes
in the back cover.
4. Pull the CN-CNT cable through the hole in the
bottom of the adaptor and re-attach the front
cover to the back cover.
5. Use the included cord clamp to fix the CN-CNT
cable to the wall.
Pull the cable around as shown in the diagram so
that external forces cannot act on the connector in
the adaptor.
63
Screws
CN-CNT cable
(Take care not to
pinch the cable)
Cord clamp