Panasonic WH-MDC05H3E5 Service Manual page 10

For embedded type
Preparation: Make 2 holes for screws using a driver.
(field supply)
Pass through
the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Top case
(Back side)
Bottom case
(Back side)
Remove the sheath. Approx. 180 mm.
Make sure the wiring connection is in the
correct direction.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Avoid the wire
being caught.
Claw (2 places)
Connect the remote
control wiring
Clamper
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
U P
Hole for
screw
Claw (2 places)
Screw
(field supply)
Remote controller
terminal board
Top case
(Back side)
Bottom case
(Back side)
Make sure the wiring
connection is in the correct
direction.
This section is for authorized and licensed electrician/water system
installer only. Work behind the front plate secured by screws must only
be carried out under supervision of qualified contractor, installation
engineer or service person.
62
Remove the coating.
Approx. 6 mm
WARNING