Table of Contents
Advertisement
1. Remove the two security torx screws from the
maintenance compartment door using a security
torx wrench. (Set the two screws aside. Use the idle
ground screw on the chassis shell as the standby
screw, and the idle floating nut on the chassis as the
standby floating nut.)
3. Remove the AC terminal cover.
4. Remove an appropriate length of the jacket and insulation layer from the AC output power cable
using a wire stripper. (Ensure that the jacket is in the maintenance compartment.)
OT-M8
U, V, and W
terminals
OT-M6
PE terminal
a. Three-core cable (excluding the ground cable)
Core wire
Insulation layer
b. Four-core cable (including the ground cable)
6
2. Open the maintenance compartment
door and adjust the support bar.
(The support bar is bound to the
chassis base.)
Jacket
Advertisement
Table of Contents
