3
Installing the Inverter
NOTE
The inverter mounting bracket has four groups of tapped holes, each group containing four
tapped holes. Mark any hole in each group based on site requirements and mark four holes in
total. Two round holes are preferred.
The inverter is delivered with M12x40 screw assemblies. If the screw length does not meet the
installation requirements, prepare M12 screw assemblies by yourself and use them together
with the delivered M12 nuts.
The following describes how to support-mount the inverter as an example. For details about how
to wall-mount the inverter, see the SUN2000-(33KTL, 40KTL)-JP User Manual.
1. Remove the security torx wrench from the
mounting bracket and set it aside.
3. Drill holes. (You are advised to apply anti-rust
paint on the hole positions for protection.)
5. Install the inverter on the mounting bracket.
2. Mark hole positions.
4. Secure the mounting bracket.
6. Tighten the security torx screws using a
security torx wrench.
3
M12
45 N· m