Page 2
WA RNI NG WA RN NG FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE THAT IS NOT COVERED BY YOUR WARRANTY Lay out all of the components on a soft surface Read Instructions carefully. as if you were preparing to do a jigsaw puzzle. Check no parts are missing.
Page 3
What you Need To Assemble the Body Mallet (Tools not provided) 3x Top Mesh (P18) Upper Post 2x End Panel (P7) (P3) Back Guard Rail (P2) Upper Post (P4) Upper Post (P6) Front Lower Post Guard (P12) Rail Lower Post (P1) 4 pcs Upper Post...
Page 4
Step 1 (H2) You will need: Left End (H2) 8x Bolt M6 x 15MM (H2) (P3) (H2) (H2) (H2) (P7) Right End (H2) (P4) (P3) (H2) (H2) (H2) (P6) (H2) (P5) Attach Upper Posts (P4 & P7) to End Panel (P3) using 4x Bolts (H2). Repeat same for Right End as shown.
Page 5
Step 3 You will need: 16x Bolt (H2) M6x 15MM (H2) (P20) (P14) (H2) (P13) (P20) Note:Postion of hole for ladder. Connect 2x End Rails (P20) to the Lower Posts using 8x Bolts (H2). Attach Front Rail (P13) and Back Rail (P14) to the Lower Posts using 8x Bolts (H2). Step 4 (H2) (P1)
Page 6
Step 6 You will need: 6x Bolt M6x 40MM (H4) (H4) (P17) Connect 3x Ladder Rungs(P17)to the Ladder Side Post (P15 & P16) using 6x Bolts (H4). Step 8 You will need: 24x Bolts (H2) M6 x 15MM (P18) (H2) (H2) (P18) (P19)
Page 7
(H1) Step 10 (H1) You will need: 4x Round End Cap (H1) (H1) (H1) Fully tighten all bolts. Insert 4x Round End Cap (H1) to the Upper Post. The job is now complete! In the interest of our environment Please dispose of all packaging thoughtfully. Page 7...
Need help?
Do you have a question about the BOBBI and is the answer not in the manual?
Questions and answers