Fuse Replacement - Reef Factory Thermo control Manual

9. Fuse replacement.

The fuses that protect the device against any damage that may occur due to a fault in the
heating or cooling system are located at the bottom of the device. If the device seems to be
operating properly but the heating or cooling system does not work, it may mean that a fuse
needs to be replaced. To do so, remove the fuse handle from the fuse socket by turning it in
accordance with the marking and replace the old fuse with a new one. Remember to
disconnect the device from its power source before replacing the fuse. Failure to do so may
result in electrocution. In order to avoid any permanent damage to the device, new fuses
should have identical specifications as the old ones. The fuse on the left side protects the
heating system, while the fuse on the right side protects the cooling system. These two
fuses are identical and interchangeable (F7 A tube fuses). The fuse in the middle is located
a bit higher and protects Thermo control device. Its parameters differ from the parameters
of both fuses described above, so it cannot be used to replace them (F400 mA tube fuse).
If you don't know how to determine whether the given fuse should be replaced or not,
contact the nearest electrical service in your area.
10. Connect to your Internet network via a computer or a mobile device. Next, go to
www.reeffactory.com
properly added to the list of your devices. You can change its name and assign it to one of
your aquariums. The serial number of your device and its firmware version are displayed in
the lower right corner of the screen. Our devices are SMART; therefore, we constantly
improve them. From time to time, you will receive information about firmware updates that
will make your device work even better.
and log in to your Smart Reef account. Check, if your device has been
Thermo control device manual 11/12