Morso 8100 Series Airtight Instructions page 4

Installation of air kit for 8100- & /8200-series
Before fitting the direct air kit, it may be necessary to remove the blanking plate. Use a
small hammer to tap and break the blanking plate supports.
The rear connecting air kit consists of a
spigot, sealing gasket and two M6 x 8mm
screws. Stick the self adhesive gasket
around the spigot flange before fixing to the
rear of the stove with the two screws.
The base connecting air kit consists of an air
box with spigot, sealing gasket and two M6
x 30mm screws and washers. Seal the self
adhesive gasket around the circular hole on
the inner face of air box. Slide the air box up
from the base of the stove and secure with
the two fixing screws.
4
When fixing the direct air supply to the pede-
stal stove the air kit consists of an air box, sea-
ling gasket and two M6 x 30mm screws and
washers. Seal the self adhesive gasket around
the rectangular hole at the top of the pedestal
and the circular hole on the inner face of air
box. Slide the air box up from the base of the
stove and secure with the two fixing screws.