Recalling Pre-Programmed Settings - Universal Remote Control Osiris MX-3500 Owner's Manual

U n i v e r s a l R e m o t e C o n t r o l , I n c .

Recalling Pre-Programmed Settings

If you didn't write down the code numbers you setup your Osiris with,
you can recall them via this simple process:
1
Enter SETUP mode by pressing and holding both MAIN and ENT
for three seconds.
Note: You have 30 seconds for each step, otherwise the Osiris will time
out automatically.
2
Go to page two of the SETUP menu via the PAGE UP button.
3
Press the RECAL button. The display changes to the recall screens. The
screen automatically switches between four screens, alternately flash-
ing page one devices and code numbers then those for page two.
Note: Pay attention to the page numbers on the bottom of the screen. Page
1 code numbers are the ones setup for the Page1 Devices. Page 2 code
numbers are the ones setup for the Page 2 Devices.
4
Write down the code numbers as they appear.
5
Return to normal operation by pressing the MAIN button twice.
27