Ir/Rf Signal Setting - Universal Remote Control Osiris MX-3500 Owner's Manual

U n i v e r s a l R e m o t e C o n t r o l , I n c .
3
Press the RF button.
The RF Settings Menu appears. See the notes on the following
4
pages for more info on each option. Make your selection by press-
ing the button you want:
After you've made a new setting and SAVED your change, use the
5
EXIT button to return to the RF settings menu to change any other
setting. Once you are finished all settings, use the MAIN button to
return to normal operation

IR/RF Signal Setting

You can set the signal to be IR line-of-sight only, RF only or IR and RF
simultaneously. Additionally, you can set the signal the same way for ALL
ten of your devices OR you can set the signal differently for each device
(the plasma TV could be set to be IR line-of-sight only, while the DVD
player and the Satellite receiver are set to be RF only). A good reason to set
the signal to RF only is to prevent too much IR being sent to a sensitive
component from two arrivals at the front panel (one directly from the
Osiris, one from the RF base station). A good reason to set the signal to IR
only is that another room has an MRF-100 base station (no RF address) so
it will receive commands from the Osiris unless it is set to IR only.
RF Button
Signal (IR, RF or Both)
Base Station ID #
Emitters - ALL or a specific Emitter
Blaster - Turn the Blaster On or Off
Exit this Menu
31