Osd (On-Screen Display) Control "Punch Through - Universal Remote Control OCE-0085A Owner's Manual

OSD (On-Screen Display) Control
"Punch Through"
This "punch through" enables you to program
the WR7 so that CBL or DVD OSD Controls
(MENU, GUIDE, INFO, EXIT, SEL and 4
Cursor Controls) will also operate in other
component modes on the remote control.
STEP 1: Press and hold the component but-
ton you want to add OSD Control to, such as
[TV] or [VCR], and the SELECT [SEL] button at
the same time for two seconds until the
Component LED light turns on.
IMPORTANT: You have 30 seconds to per-
form the next step while you are in program-
ming mode. If you do not press a button with-
in 30 seconds, the component LED light will
turn off. The remote will exit the programming
mode and you will have to start over.
STEP 2: Press the [MENU] button. The
component LED will blink once.
COMPONENT
BUTTONS
SELECT
MENU
STEP 3: Press either the [CABLE/SAT] or
[DVD] button that you want to use as the
source of OSD Control. The component LED
will blink three times to confirm it is saved.
Page 29