Programming Wr7 Using The Learning Method - Universal Remote Control OCE-0085A Owner's Manual

Programming WR7 using
the Learning Method
STEP 1: Line up the WR7 to the remote control
you want to "learn" from, head--to--head as shown
below. Start with both remotes' IR windows touch-
ing (or nearly touching).
STEP 2: On the WR7, press the Component
button that you want to program (in this case
the button that says TV) and the ENTER [ENT]
button at the same time. Hold down both but-
tons for two seconds until the TV Component
button light turns on. This signals that you are
in programming mode.
IMPORTANT: You have 30 seconds to per-
form the next step while you are in program-
ming mode. If you do not press a button with-
in 30 seconds, the component LED light will
turn off. The remote will exit the programming
mode and you will have to start over.
STEP 3: Press any button on the WR7 that
you want to teach a command to. For example,
if you want to teach the [MUTE] button on the
WR7 the TV Mute command from the other
remote, first press the [MUTE] button on the
WR7 and the TV component button LED light
will blink once indicating that the WR7 is ready
to learn the command.
Page 16