Safety; System Set-Up; Mounting Options; System Power-Up - Pace MTS 200 Operation And Maintenance Manual

Safety

Safety Guidelines
The following are safety precautions that personnel must understand and follow when using or
servicing this product.
1. POTENTIAL SHOCK HAZARD - Repair procedures on PACE products should be
performed by Qualified Service Personnel only. Line voltage parts may be exposed
when the equipment is disassembled. Service personnel must avoid contact with these
parts when troubleshooting the product.
2. To prevent personnel injury, adhere to safety guidelines in accordance with OSHA and
other applicable safety standards.
3. SensaTemp handpiece heaters, installed tips, and heater cartridge tips are hot when the
handpiece is powered on and for a period of time after power off. DO NOT touch either
the heater or the tip. Severe burns may result.
4. PACE Tip & Tool Stands and handpiece cubbies are designed specifically for use with
the associated handpiece and houses it in a manner that protects the user from
accidental burns.
handpiece in its holder after use and allow for cooling before storing.
5. Always use PACE systems in a well ventilated area. A fume extraction system such as
those available from PACE are highly recommended to help protect personnel from
solder flux fumes.
6. Exercise proper precautions when using chemicals (e.g., solder paste). Refer to the Material
Safety Data Sheet (MSDS) supplied with each chemical and adhere to all safety precautions
recommended by the manufacturer.

System Set-Up

To set up an MTS system, use the following steps and associated images.
1. Store the shipping container in a convenient location. Reuse of the
container will prevent damage if you store or ship your system(s).
2. Place the Power Switch in the "OFF" or "0" position.

Mounting Options

1. MTS systems can be placed directly on a work surface
2. MTS systems can be placed inside the optional Tool Chest.
System Power Up
1. Insert the female end of the power cord into
the AC Power Receptacle on the rear panel
of the power source.
2. Plug the prong end (male end) of the power
cord into an appropriate 3 wire grounded AC
supply receptacle.
CAUTION: To insure operator and ESD/EOS safety, the AC power
NOTE: Ensure that the system is placed in a well-ventilated area.
equipment is recommended when melting solder or heating flux or flux containing
solders.
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Always store the handpiece in its holder.
supply receptacle must be checked for proper grounding before initial operation.
MTS Systems Operation Manual
Be sure to place the
Power
Switch
Setback/Auto-Off
Switches
AC Power
Receptacle/Fuse
Holder
Fume extraction
Page 5 of 11