Related Manuals for Worx WX529L
Summary of Contents for Worx WX529L
- Page 1 Cordless Circular Saw Scie circulaire sans fil Sierra circular inalámbrica WX529L WX529L.9...
-
Page 2: Product Safety
PRODUCT SAFETY power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. b) Avoid body contact with grounded WARNING: Some dust created by power surfaces such as pipes, radiators, ranges sanding, sawing, grinding, drilling and refrigerators. There is an increased risk and other construction activities contains of electric shock if your body is grounded. -
Page 3: Safety Instructions For All Saws
h) Do not let familiarity gained from c) When battery pack is not in use, keep it frequent use of tools allow you to away from other metal objects, like paper become complacent and ignore tool clips, coins, keys, nails, screws or other safety principles. -
Page 4: Further Safety Instructions For All Saws
e) Hold the power tool by insulated gripping c) When restarting a saw in the workpiece, surfaces only, when performing an center the saw blade in the kerf and operation where the cutting tool may check that saw teeth are not engaged into contact hidden wiring. -
Page 5: Safety Warnings For Battery Pack
Recharge only with the charger specified by WORX. Do not use any charger other than that specifically provided for use SAFETY WARNINGS FOR with the equipment. A charger that is... - Page 6 SYMBOLS Lock To reduce the risk of injury, user must read instruction manual Warning Unlock Wear ear protection Wear eye protection POSITEC Inc. has established a partnership with the RBRC Corporation to recycle any Positec batteries with the RBRC-call2recycle seal. For environmental protection, please do not discard batteries in the Wear dust mask trash.
- Page 7 Cordless Circular Saw...
-
Page 8: Technical Data
TECHNICAL DATA LOCK-OFF BUTTON Type WX529L WX529L.9 (5 - ON/OFF SWITCH designation of machinery, representative FRONT HANDLE of circular saw) SPINDLE LOCK BUTTON WX529L WX529L.9 BASE PLATE ANGLE SCALE Voltage Max.** BASE PLATE BEVEL LOCK KNOB CUTTING MARK, 45° No load speed 3600/min CUTTING MARK, 0°... - Page 9 23 22 24 25 Cordless Circular Saw...
- Page 10 Cordless Circular Saw...
-
Page 11: Maintain Tools With Care
OPERATING INSTRUCTIONS WORKING TIPS FOR YOUR TOOL NOTE: Before using the tool, read the instruction book carefully. If your power tool becomes too hot, please run your circular saw no load for 2-3 minutes to cool the INTENDED USE: motor. Avoid prolonged usage at very low speeds. The tool is intended for ripping and cross-cutting Protect saw blades against impact and shock. -
Page 12: Troubleshooting
TROUBLESHOOTING Symptom Possible Causes Possible Solution Tool will not start when Battery pack not plugged in. Check to make sure battery pack operating the on/off switch. is connected well into a working Battery pack is powered off. outlet. Carbon brush has worn down. Charging the battery.