The Bobbin Thread Broke Or Ran Out While Sewing - ELNA Air Artist Faq

Machine
F A Q
6
A6-2
The needle thread breaks.
Check and make sure followings. Rethread the machine as described in step
A6-1 and restart sewing.
• Needle thread is threaded properly.
• Thread is not jammed or tangled.
• Needle is correctly inserted. Needle clamp screw is secured.
• The needle is not bent or blunt.
• The spool holder holds the spool of thread firmly.
• Appropriate threads and needles are being used. (Refer to FAQ Embroi-
dery Q1 and Q2)
• Fabrics are not too thick or too hard to penetrate. (Refer to FAQ Em-
broidery Q3)
• Hold the end of the thread lightly when start sewing.
Q7

The bobbin thread broke or ran out while sewing.

A7-1
The bobbin thread ran out.
Remove the hoop from the embroidery machine. Replace the bobbin with the
new one. Press the stitch back button (-) to move the hoop position 10 stitches
before and continue sewing.
Press the stitch back button (-) to move the hoop backward one
stitch. Check the needle position and the number of stitches on the
real-time screen. Hold down the button to travel faster and jump 10,
100 or 500 stitches at a time.
You can wind the bobbin thread without having to complete
stitching the current design. To wind the bobbin, stop the machine
and shift the bobbin winder spindle to the right. The machine is
switched to the bobbin winding mode. Wind the bobbin.
Shift the bobbin winder spindle to the left and restart sewing after
Be sure to stop the machine before shifting the bobbin
the bobbin winding.
winder spindle.