Conventions; Compliance; Electrical Safety; Laser Safety - Datalogic DM3610 Reference Manual

CONVENTIONS

WARNINGS or CAUTIONS: This symbol identifies a hazard or procedure that, if
incorrectly performed, could cause personal injury or result in equipment damage. It is
also used to bring the user's attention to details that are considered IMPORTANT.
HIGH VOLTAGE CAUTION: This symbol alerts the user they are about to perform
an action involving, either a dangerous level of voltage, or to warn against an action that
could result in damage to devices or electrical shock.
LASER CAUTION: This symbol alerts the user they are about to perform an action
involving possible exposure to laser light radiation.
ESD CAUTION: This symbol identifies a procedure that requires you take measures to
prevent Electrostatic Discharge (ESD) e.g., use an ESD wrist strap. Circuit boards are
most at risk. Please follow ESD procedures.
NOTES: This symbol draws attention to details or procedures that may be useful in
improving, maintaining, or enhancing the performance of the hardware or software being
discussed.

COMPLIANCE

ELECTRICAL SAFETY

This product conforms to the applicable requirements contained in the European Standard for
electrical safety EN-60950 at the date of manufacture.

LASER SAFETY

The following information is provided to comply with the rules imposed by international
authorities and refers to the correct use of the DM3610 dimensioner.
Standard Regulations
This dimensioner uses a low-power laser diode. Avoid staring at the beam as one would with
any very strong light source, such as the sun.
Take care when installing the laser device to avoid inadvertent laser beam contact with the
eye of an observer, including through reflective surfaces.
This product conforms to the applicable requirements of both EN60825-1 and
CDRH 21 CFR1040 at the date of manufacture. The DM3610 uses a visible laser diode (red)
658 nm typical, Collimated < 1.5mR, <9.6mW peak power, <1.0mW Average power, Class
3R (IEC60825-1), Class II (CDRH 21CFR1040), in the dimensioning process.
There is a safety device which allows the laser to be switched on only if the motor is rotating
above the threshold for its correct scanning speed.
WARNING: Use of controls or adjustments or performance of procedures other than
those specified herein may result in exposure to hazardous visible laser light.
v