What You Need To Know About Your Application - Datalogic DM3610 Reference Manual

MECHANICAL INSTALLATION

2.3 WHAT YOU NEED TO KNOW ABOUT YOUR APPLICATION

To assure you get optimal performance out of your Dimensioning System, it must be installed
to meet the complete needs of your application. Therefore, take the time to know the details
of your application.
Below is what you will need to know before you can begin installation:

Conveyor Specifications
o Conveyor type: Belt, tilt-tray, cross belt, other?
o What is the conveyor width?
o What is the conveyor speed?
o Does conveyor speed vary or is it constant?
o Will bar code scanning also take place?
o Where is the dimensioning area to be located on your conveyor?
o Is the conveyor surface flat?

Product and Dimensioning Specifications
o Are the packages being transported always singulated (not touching) or non-
singulated (possibly touching)?
o Are products always cuboidal (box shaped), non-cuboidal (irregular shaped) or
is there a mixture of both?
o Is side-by-side object dimensioning (non-singulated) required?
o How many different product sizes may be involved?
o Are products justified: toward/away from dimensioner/reader, centered, or
variable?

Application Specifications
o What will be done with the dimensioning information?
o How will this information be used in your application?
o What are your communication requirements?
While it is nearly impossible to cover all application configurations, the next several pages
provide the basics on determining how to mechanically install your dimensioning system. If
you need additional assistance, feel free to contact your sales representative or customer
service.
2
11