Specifications - Toro Reelmaster 3550-D Service Manual

Specifications

Frame Construction: Precision machined die cast alu-
minum cross member with two (2) bolt--on cast alumin-
um side plates.
Cutting Unit/Reel Size
Reelmaster 3550- -D: 18 in. (45.7 cm) in length with
5 in. (12.7 cm) diameter 8 or 11 blade reel. Optional
22 in. (55.9 cm) 8 and 11 blade reels are available
for the rear cutting unit positions.
Reelmaster 3555- -D: 22 in. (55.9 cm) in length with
5 in. (12.7 cm) diameter 8 or 11 blade reel.
Reelmaster 3575- -D: 22 in. (55.9 cm) in length with
7 in. (17.8 cm) diameter 8 or 11 blade reel.
Reel Construction: High strength steel blades are thru
hardened and impact resistant. Reel blades may have
a radial or forward swept design.
Reel Bearings: Two sealed, stainless steel ball bear-
ings support the reel shaft.
Reel Drive: The reel weldment shaft is a 1 5/16 inch
(33.3 mm) diameter tube with drive inserts threaded into
both ends. The reel drive inserts have an eight (8) tooth
internal spline.
Height- -of- -Cut (HOC): Cutting height is adjusted on
the front roller by two (2) vertical screws. Effective HOC
may vary depending on turf conditions, type of bedknife,
roller type and installed attachments.
DPA Cutting Units
Figure 1
Bedknife: A replaceable, single edged bedknife is fas-
tened to a machined cast iron bedbar with screws. A
variety of bedknives are available for specific cutting ap-
plications.
Bedknife Adjustment: Dual screw adjustment to the
reel; detents corresponding to 0.0007 inch (0.018 mm)
bedknife movement for each indexed position.
Front and Rear Rollers: Greaseable through--shaft
front and rear rollers are used with these cutting units.
Both rollers use the same heavy duty ball bearings.
Counterbalance Weight: A cast iron weight mounted
opposite to the hydraulic drive motor balances the cut-
ting unit. 5 in diameters reels us a 7 lb. (3.2 kg) weight
and 7 in. Diameter reels use a 16 lb (7.4 kg) weight.
Cutting Unit Weight (without counterbalance weight):
18" x 5" dia. Reel, 8 Blade
18" x 5" dia. Reel, 11 Blade
22" x 5" dia. Reel, 8 Blade
22" x 5" dia. Reel, 11 Blade
22" x 7" dia. Reel, 8 Blade
22" x 7" dia. Reel, 11 Blade
Options:
Refer to Cutting Unit Operator's Manual for available op-
tions for your Reelmaster cutting unit.
Page 7 - - 2
79 lb. (35 kg)
81 lb. (36 kg)
87 lb. (39 kg)
91 lb. (41 kg)
118 lb. (54 kg)
121 lb. (55 kg)
Reelmaster 3550--D/3555--D/3575--D