Register The Handset - Uniden WDECT 2345+1 Owner's Manual

Register the Handset

If you purchase an expansion handset (WDECT2305 model), you need to register
the handset before use. Only one handset can be registered at a time.
Handsets supplied with the phone are registered to the base by the factory. When
!
charged, pre-registered handsets display a handset ID number. Handsets that
Your phone may
be compatible have not been registered display
with other
you register an extra handset to the base, the handset ID will be assigned.
Uniden Digital
Expandable
Systems. 1) Before registering the extra handset, the battery pack MUST be charged for 15-
Please visit our
20 hours.
website at
2) With the main base in standby mode, press the
www.uniden.com.au,
www.uniden.co.nz
3) Press /volume up/down
for model
press the OK soft key.
number
4) On the handset, press and hold the
confirmation.
To cancel registration, press the
5) While the handset is registering,
When Registration Complete
the base. If Registration Failed
by following the same steps above.
The WDECT2380 expansion handset can be registered to the base by following
the same steps above.
Place handset on main base to register.
MENU soft key on the base.
on the base to select HS Registering, and then
#/ key for two seconds.
CANCEL soft key on the base.
Handset Registering will appear in the LCD.
is displayed, the handset has been registered to
appears, please try these steps again. the base
[17]
When