Uniden WDECT 2345+1 Owner's Manual page 27

2) Press /volume up/down to select CIDW
On or CIDCW Off.
3) Press the OK soft key on the base).
You will hear a confirmation tone.
Setting the Dial Mode (Australia Only)
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone
dialing; the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.
!
If you are not sure of your dialing system, make a trial call. If the call connects,
leave the setting as is; otherwise set the unit to pulse dialing.
!
If your phone system requires pulse dialing and you need to send DTMF tones
in certain situations during a call, you may switch over to tone dialing (refer to
"Tone Dialing Switch-over" on page 36).
1) Press menu/del (or the MENU soft key
on the base). Select the Global Setup menu,
and then the Dial Mode submenu.
2) Press /volume up/down to select Tone
Pulse (the initial setting is Tone).
3) Press select/ (or the OK soft key on the
base). You will hear a confirmation tone.
CIDCW
CWDX On
CWDX Off
Dial Mode
Tone
or
Pulse
[26]