Resistance Test - Stop Function - Husqvarna T435 Workshop Manual

Safety equipment

6.8 Resistance test - stop function

1
Remove the starter, see "Dismantling the starter".
2
Remove the cold air wire.
Clean the contact areas and check the resistance
as follows:
Test the resistance by connecting a multimeter to
the ignition coil. Note! The power switch must be
in the "on" position to get the correct reading, see
fi gure 26.
The resistance must not exceed 0.5 Ohm with the
power switch in the "on" position.
When assembling the cold air wire, make sure that the
ignition cable is fi tted into the slot.
22
– English
Fig 25
Fig 26
Fig 27