Banner Sure Cross DX80N9X6S-P2 Manual

Sure Cross
®
Datasheet
®
The Sure Cross wireless system is a radio frequency network with integrated I/O that can operate in most environments
and eliminate the need for wiring runs. Wireless networks are formed around a Gateway, which acts as the wireless
network master device, and one or more Nodes.
For additional information, updated documentation, and accessories, refer to Banner Engineering's website,
www.bannerengineering.com/surecross.
Models Frequency
DX80N9X6S-P2 900 MHz ISM Band
DX80N2X6S-P2 2.4 GHz ISM Band
DX80...C (IP20; NEMA 1) models are also available. To order this model with an IP20 housing, add
a C to the end of the model number: DX80N9X6S-P2C.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to
serious injury or death. This device does not include the self-checking redundant circuitry necessary
to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an
energized or de-energized sensor output condition.
CAUTION: Never Operate 1 Watt Radios Without Antennas
To avoid damaging the radio circuitry, never power up Sure Cross
MultiHop (1 Watt) radios without an antenna.
CAUTION: Electrostatic Discharge (ESD)
ESD Sensitive Device. This product uses semiconductors that can be damaged by electrostatic
discharge (ESD). When performing maintenance, care must be taken so the device is not damaged.
Disconnect power from the device when accessing the internal DIP switches. Proper handling
procedures include wearing anti-static wrist straps. Damage from inappropriate handling is not covered
by warranty.
Original Document
155862 Rev. G
Performance Node
• Wireless industrial I/O device with four selectable discrete inputs, four
sourcing discrete outputs, two universal analog inputs, and two 0 to 20 mA
analog outputs
• Selectable transmit power levels of 250 mW or 1 Watt for 900 MHz models
and 65 mW for 2.4 GHz models
• 10 to 30 V dc power input
• DIP switches for user configuration
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division
Multiple Access (TDMA) control architecture ensure reliable data delivery
within the unlicensed Industrial, Scientific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and
Node, including fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined
conditions
Environmental
Rating
IP67, NEMA 6
I/O
Inputs: Four selectable discrete, two 0 to 20 mA (default) or
0 to 10 V (user configurable)
Outputs: Four sourcing discrete, two 0 to 20 mA
®
Performance or Sure Cross
15 May 2016
155862