Program Band Select Mode - Uniden BEARCAT BC95XLT User Manual

To start chain search hold mode, press Hold in
chain search mode. The scanner stops searching
HOLD
and
Func +
and pressing Func +
direction upward.
current search direction.
Storing Frequencies Found During
Chain Search into Channel Memory
You can store frequencies you find in chain search
mode or chain search hold mode.
1. Press Func + Pgm in chain search mode or
chain search hold mode. The lowest blank
channel and bank appear.
2. Press E to store the frequency into the blank
channel. To select another channel, press Func
+ or Func +
also press 0-9 to select the bank.
If you try to save a frequency that is already stored,
the scanner sounds an error tone and displays the
channel that was duplicated. If you entered the fre-
quency by mistake, press . To enter the frequency
anyway, press E to accept.
The scanner sets itself to program mode after you
store a frequency.

Program Band Select Mode

You can use this mode to define the search range
used during a chain search in each search bank. To
set the scanner to program band select mode, press
Func and PSrc. SRCH appears. Then select a
search bank.
appears. In this mode, pressing
changes the search direction downward
or
changes the search
appears according to the
before you press E. You can
Special Features
43