Connecting The Ethernet Cables; Connecting A Copper Ethernet Port; Connecting A Fiber Port - H3C WX2540H Installation Manual

Figure 10 Setting the terminal emulation in Test Properties dialog box

Connecting the Ethernet cables

Connecting a copper Ethernet port

1. Connect one end of the Ethernet cable to the copper Ethernet port on the device, and the other end
to the Ethernet port on the peer device.
2. After powering on the device, examine the LEDs of the fixed copper Ethernet port.
For more information about the LED description, see

Connecting a fiber port

No transceiver module is provided with the device. The device supports only LC-type fiber connectors. For
transceiver module specifications, see
Follow these guidelines when you connect an optical fiber:
Never stare into an open fiber port, because invisible rays might be emitted from the fiber port.
•
Install dust plugs in empty fiber ports.
•
• Never bend a fiber excessively. The bend radius should not be less than 10 cm (3.94 in).
Make sure the Tx and Rx ports on a transceiver module are correctly connected.
•
To connect the device to the network through an optical fiber:
"Appendix B
"Appendix A Chassis views and technical
12
LEDs."
specifications."