Uniden UH088sx Owner's Manual page 36

PRIORITY SCAN CHANNEL
To set a priority scan channel:
1. Press select/ momentarily four times while in
standby mode to enter Priority Scan Channel
mode. The current priority channel will be
indicated.
2. Press or key to increase or decrease the
desired channel number.
3. Press select/ three times to confirm and exit
to standby mode. PRI will be displayed when a
priority channel has been selected.
BCL (Busy Channel Lockout) ON/OFF
BCL is used when CTCSS or DCS is selected to prevent transmission when
the uh064sx detects a transmission from another unit using the same CTCSS
or DCS code.
To set BCL ON/OFF:
1. Press select/ momentarily five times while in
standby mode to enter BCL ON/OFF
The current BCL status will be indicated.
2. Press or key to select
3. Press select/ two times to confirm and exit to
standby mode. BCL will be displayed when BCL on
has been selected.
SCAN CHANNEL MEMORY
To store a channel into Scan Channel Memory:
1. Select desired channel using ch/txp
2. Press and hold mem/SCN key.
Repeat steps 1 and 2 to clear channel from Scan Channel Memory.
mode.
ON (on) or OFF (oF).
key and or key.
MEM will appear on the display.
(11)