Toro STX-38 Operator's Manual page 41

Storage
1. Park the machine on a level surface, engage the
parking brake, and lower the hydraulic lift.
2. Shut off the engine and remove the key.
3. Remove dirt and grime from the external parts of
the entire machine, especially the engine. Clean
dirt and chaff from the outside of the engine
cylinder head fins and blower housing.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
engine, hydraulic pumps, and motors.
4. Service the air cleaner; refer to
Cleaner (page 23).
5. Grease the machine; refer to
Machine (page 22).
6. Change the crankcase oil; refer to
Engine Oil (page
7. Remove the spark plug and check the condition
of it; refer to Servicing the Spark Plug(s) (page
27).
8. For storage over 30 days, prepare the machine
as follows:
A. Add a petroleum-based
stabilizer/conditioner to fuel in the
tank. Follow the mixing instructions from
the stabilizer manufacturer. Do not use
an alcohol-based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when it is mixed with fresh fuel and
is used at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C. Shut off the engine, allow it to cool, and
drain the fuel tank using a pump type
syphon.
D. Start the engine and run it until it shuts off.
E. Engage the choke.
F. Start and run the engine until it does not
start again.
G. Dispose of fuel properly. Recycle as per
local codes.
Important:
Do not store fuel containing
stabilizer/conditioner longer than the
duration recommended by the fuel-stabilizer
manufacturer.
Servicing the Air
Greasing the
Changing the
25).
9. With the spark plug removed from the engine,
pour 2 tablespoons of engine oil into the
spark-plug hole.
10. Place a rag over the spark-plug hole to catch
any oil spray, then use the starter or recoil
handle to crank the engine and distribute the oil
inside the cylinder.
11. Install the spark plug, but do not install the wire
on the spark plug.
12. Charge the battery; refer to
(page 30).
13. Check and adjust the track tension; refer to
Checking and Adjusting the Track Tension (page
32).
14. Check and tighten all fasteners. Repair or
replace any part that is damaged.
15. Paint all scratched or bare metal surfaces with
paint available from your Authorized Service
Dealer.
16. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place.
17. Cover the machine to protect it and keep it clean.
41
Charging the Battery