Manufacturer's Default Table (Mdt - Uniden Data 2000 Wireless CDPD PC Card Manual

Uniden Data 2000 Wireless CDPD PC Card
Most of the configuration changes you make using AT commands, are
made to the Current Active Table only. (The only exception is the AT
SLI SLIP [MDT][SPDT][UDT] command which automatically saves the
changes to the default table you have defined.) Any changes made to
the CAT can be saved to a particular default table by typing in the AT
command AT SAVECFG [MDT] [SPDT][UDT] or AT&W for the UDT.
The SPDT and UDT contain the same settings as the MDT when
shipped from the factory.
The following table lists all of the configuration parameters that are
stored in the MDT, UDT, and SPDT, as well as their default values.
Setting
Baud Rate
Statistics
Auto Registration
Compression
Encryption
SPNI
WASI
SPI
Side Preference
Active NEI
Mode
STS Update Interval
Detailed information regarding each default table is described in the
following sections.
D.1.1 Manufacturer's Default Table (MDT)
The Manufacturer's Default Table (MDT) contains the configuration
information defined by the manufacturer.
The values in the MDT can be read by any user, but can be modified
only by Uniden service personnel using a login with a MDT password.
D-2
Default Value
9600 bps
0 (statistics disabled)
1 (true)
1 (true)
1 (true)
0 (accept all)
0 (accept all)
0 (accept all)
3 (side A preferred)
1
AT command mode
60 sec