Installation Procedures/Windows Nt - Uniden Data 2000 Wireless CDPD PC Card Manual

Uniden Data 2000 Wireless CDPD PC Card

2.7 Installation Procedures/Windows NT

Follow the steps below to create Dial-up Networking to connect your
Data 2000 to the Internet.
1. Turn your host computer off.
2. Insert the Uniden Data 2000 into the PC Card slot of your
host computer.
3. Move the Uniden Data 2000 On/Off Power Switch to the
'on' position.
4. Turn your host computer on.
Note: Windows NT does not support hot swapping, (the process
of inserting or removing a PC Card into or from a PC Card slot
while the host computer is running). Therefore, you must turn your
host computer off before inserting or removing the Uniden
Data 2000.
Uniden recommends using a third party vendors' PC card drive to
enable hot swapping. Please contact 1-888-6-UNIDEN, or visit our web-
site www.uniden.com to obtain PC card driver information.
To check which COM port was selected during the setup process, take
the following steps:
5. Click the Start button on your Windows NT desktop, then
select Settings, Control Panel.
6. Double-click the PC Card (PCMCIA) icon.
7. Select Uniden Data 2000 PC Card.
8. Click Properties.
9. The COM port that was selected during the setup process is
displayed on the Card Info tab.
2-34