Uniden XSA650 Owner's Manual page 35

PROBLEM
Base Unit
doesn't ring
Answering System
does not work.
Answering System
does not
answer calls.
Message are
incomplete.
After a power
failure, the outgoing
message is deleted.
Message counter
LED flashes 88
No sound on the
Base Unit Speaker
Cannot access
remote call-in
feature from another
touch-tone phone
Cannot record
outgoing message
Clock losses time
SUGGESTION
Set the Base Unit Ringer switch to ON.
Make sure the base unit is plugged in.
Make sure the Answering System is turned ON.
Disconnect the AC adaptor to reset the phone.
Set the REC TIME/ANN/4/1 switch in either the 4-minute
or 1-minute position.
The memory may be full. Delete some or all of the saved
messages.
The incoming messages may be too long. Remind callers
to leave a brief message.
The memory may be full. Delete some or all of the saved
messages.
The answering machine has a flash memory with no
battery backup. Record your personal outgoing message
again. The incoming messages should still remain.
There has been a power failure. Press Reset to reset the
Answering System.
Adjust the volume control on the Base Unit
Make sure you're using the correct PIN code.
Make sure that the touch-tone phone you're using can
transmit the tone for at least two seconds. If it cannot, you
may have to change to another phone
The memory may be full. Delete some or all of the saved
messages
The power to the base unit has been interrupted. Reset the
clock as detailed on page 21 of this owner's manual.
29