Installing The Battery Pack; Charging The Handset - Uniden XSA650 Owner's Manual

The battery connector will fit
together only one way. Make
sure the connector is
properly aligned. Use only
the Uniden battery pack
(model BT-434)
Replace the handset on the
base after use if convenient.
However recharging the
battery is only necessary
when the low battery
indicator is lit. On a
monthly basis use the phone
until the low battery
indicator appears. Then
charge the battery for 15-20
hours.
12

Installing the Battery Pack

The rechargeable Nickel-Cadmium battery pack must be fully charged before using
your phone for the first time. Before plugging the phone line into your new phone,
you must charge the battery for approximately 15-20 hours without interruption.
1. Remove the Handset
battery cover.
2. Plug the battery's cable
into the handset and
place the battery pack
inside the battery
compartment.
3. Replace the battery cover.

Charging the Handset

1. Place the handset on the base to charge. (The handset will charge only in
the face-down position.) OR place the handset on the charger keypad facing
forward (XSA660 only).
2. Make sure the status LED lights on the base or change LED lights on the
charger. If the LED doesn't light, check to see that the AC Adaptor is plugged
in and switched on. Also that the Handset is making good contact with the
Base Unit and charger charging contacts.
Continuous Battery Charging
For the best battery performance, return the Handset to the Base Unit at the end
of the day. This keeps the battery fully charged.
(Spare Handset - XSA660 only)