Leaving A Memo Message; Remote Operation; Using A Touch-Tone Phone - Uniden XCA550/55 Instruction Manual

Leaving a Memo Message

You can use the XCA550/55 to leave a Memo
Message for someone else who uses your
Answering System.
To record a memo message, follow these steps:
1. Press and hold
memo until you hear
a long tone, and
then release the
key.
Two begin flashing
in the display.
You can operate your XCA550/55 while you're away from home by calling from any touch-tone phone.
When using this feature, remember these important guidelines.
You should change your Personal Identification Number (PIN) before using your Handset. When you
first apply power, the code is set to
You cannot change the Time and Day Stamp or your PIN code from a touch-tone phone.

Using a Touch-Tone Phone

You can operate your Answering System using
any touch-tone telephone. Use this function to
check for recorded messages, play or delete
messages, or even record a new outgoing
message.
1. Call your telephone number.
2. During the outgoing
message playback,
#
press followed
by your PIN number.
3. The Answering System announces the Time
and Day Stamp followed by the number of
messages stored in memory.
XCA550/55
2. Speak into the

Remote Operation

00
.
4. You then hear intermittent beeps indicating
5. Use this chart to
6. When you've finished, hang up to exit the
microphone. When
you are finished
recording, press
memo again.
There is a tone,
and the Message
Counter begins to
flash, and the
system returns to
standby.
that the system is in the Command Waiting
Mode.
Note: You must enter a command within 20
seconds or the Answering System hangs up
and returns to Standby.
select the function
you want.
system.
Your Answering System automatically returns
to Standby.
Function Press
Repeat #1
#2
Play
#3
Skip
Delete Message #4
Answer On/Off #5
Stop #6
Record OGM #7
Play New Message #8
Replay OGM #9
Help Menu #0
27