Getting Your Messages - Uniden EZX290 User Manual

Ans. Setup menu options
You can change the answering system options from any handset. Just
open the menu and select Ans. Setup.
Security Code
Ring Time
Record Time
Message Alert
Ans. Language Change the language of the system's voice prompts.
Call Screen
Ans. On/off

Getting Your Messages

Accessing your answering system from a handset
You can access your
system from a handset
whenever
the phone
is in
standby.
Use Use
During

remote
operation, the
phone beeps to
let you know it's
waiting for your next command.
You can press the number key next to the commands instead of

scrolling through them.
Enter a 2-digit PIN so you can access your answering
system from any touch-tone phone (see page 21).
Set the number of rings (2, 4, or 6) before the answering
system answers the phone. Choose Toll Saver (TS) to have
the system pick up after 2 rings if you have new messages
or after 4 rings if you don't.
Set the amount of time callers have to leave a message,
either 1 minute or 4 minutes. Choose Announce Only if
you don't want the system to let callers to leave a message.
Have the system beep every 15 seconds when you have a
new message; the beeping stops when you listen to all your
new messages. (To mute the alert without listening to your
messages, press any key on the base.)
Turn on the call screen feature so you can hear callers as
they leave messages on the base speaker (see page 20).
Turn your answering system on or off. (To turn your system
on or off from the base, just press
1:Repeat 1:Repeat 3:Skip 3:Skip
2:Play 2:Play 4:Delete 4:Delete
PHONEBOOK/LEFT PHONEBOOK/LEFT
to the previous option. to the previous option.
Press Press
choose the current option. choose the current option.
Press Press
MUTE/MESSAGES MUTE/MESSAGES
remote operation mode. remote operation mode.
5:Stop 5:Stop
[ / /select] [ / /select]
to go to go
SELECT/MENU SELECT/MENU
.)
oN/oFF
to start to start
6:SelectGreeting 6:SelectGreeting
8:RecNewGreeting 8:RecNewGreeting
Use Use
CALLER ID/RIGHT CALLER ID/RIGHT
go to the next option. go to the next option.
to to
Press Press
FLASH/EXIT FLASH/EXIT
remote operation mode. remote operation mode.
to to
to stop to stop
9