Table of Contents
Advertisement
General instructions on damage to property and the product
3 General instructions on damage to
property and the product
The following instructions apply to chapters 6 to 14.
Danger from improper handling!
Product can get damaged!
▶
Do not expose the product to excessive mechanical loads.
▶
Never grab or climb onto the product.
▶
Do not place/lay any objects on the product.
▶
Do not strike the drive shaft of the axial piston unit.
▶
Do not set/place the axial piston unit on the drive shaft or assembled parts.
▶
Do not strike assembled parts (for example, sensors or valves).
▶
Do not strike sealing surfaces (for example, at working ports).
▶
Leave the protective covers on the axial piston unit until you connect the lines.
▶
Disconnect all electrical connectors before electro-welding or painting
operations.
▶
Make sure that the electronic components (for example, sensors) do not
become electrostatically charged (for example, during painting operations).
Risk of property damage due to inadequate lubrication!
Damage or destruction of product possible!
▶
Never operate the axial piston unit with insufficient hydraulic fluid. Specifically,
make sure that the rotary group has sufficient lubrication.
▶
When commissioning a machine/system, make sure that the housing area and
the working lines of the axial piston unit are filled with hydraulic fluid and
remain filled during operation. Air inclusions in the forward drive shaft bearing
are to be prevented, especially with the installation position "drive shaft
upwards".
▶
Check the hydraulic fluid level in the housing area regularly; if necessary,
recommission. With above-reservoir installation, the housing area may drain
via the drain line after longer periods of disuse (air enters via the shaft seal)
or via the working line (gap leakage). This means the bearings are insufficiently
lubricated when the system is turned on.
NOTICE
RE 92105-01-B/06.2017, A4CSG, Series 3x, Bosch Rexroth AG
15/68
Hide quick links:
Advertisement
Table of Contents
